Upper Eyelid Reconstruction with a Lower Eyelid Bridge Flap
All content on Eyewiki is protected by copyright law and the Terms of Service. This content may not be reproduced, copied, or put into any artificial intelligence program, including large language and generative AI models, without permission from the Academy.
Introduction
Upper eyelid reconstruction with a lower eyelid bridge flap, commonly known as the Cutler-Beard procedure, is a two-stage technique for repair of large (>50%) full-thickness upper eyelid defects. It was first described in 1955 by Norman Cutler and Crowell Beard (1). A full-thickness flap of lower eyelid is advanced behind the intact lower eyelid margin (the “bridge”) and sutured into the upper eyelid defect. The flap is divided several weeks later at the level of the upper eyelid margin (1)(2).
Earlier upper eyelid reconstructions required additional stages or relied on periorbital rotational flaps. The bridge flap rebuilds both lamellae with tissue that matches the upper eyelid in texture, color, and thickness (1)(2). Since the lower eyelid has only about 4-5mm tarsus, tarsus cannot be transposed to the upper eyelid as is done in the Hughes procedure, which borrows upper eyelid tarsus for the lower lid. Because the flap carries little to no tarsus, cicatricial ectropion and retraction of the new eyelid are common complications, and several modifications incorporate a tarsus substitute (2)(4).
Indications
Upper eyelid defects of up to one third of the eyelid can usually be closed by direct approximation. Medium sized defects can be reconstructed using the semi-circular advancement flap (Tenzel) or the McGregor flap. Larger, full-thickness defects may benefit from the Cutler-Beard procedure. Defects of this size usually result from tumors, traumas, congenital colobomas, and scar contractures.

Surgical Technique
The steps below follow the original technique as described by N Cutler and C Beard (1):
First Stage:
- The upper eyelid defect is prepared by wide excision of the tumor, or by freshening any epithelialized edges in traumatic cases and is shaped as a rectangle.
- A horizontal full-thickness incision is made in the lower eyelid just below the inferior border of the tarsus, approximating the width of the upper eyelid defect.
- Vertical full-thickness incisions are made from each end of the horizontal incision down to the lowest point of the inferior fornix, creating a skin-muscle-conjunctiva advancement flap.
- The skin at the base of the flap is undermined onto the cheek, freeing the flap.
- The flap is carried beneath the intact bridging lower eyelid margin and up to the upper eyelid defect.
- The lower eyelid flap is divided into anterior and posterior lamallae, down to the inferior fornix.
- The conjunctival flap is sutured into the upper lid conjunctiva with 6-0 vicryl sutures with inclusion of the cut end of the levator aponeurosis.
- *Modification* Tarsal substitutes can be sutured in this layer between the anterior and posterior lamellae to prevent post-operative lid malpositions (see below)
- The anterior lamellae is then sutured into the upper lid defect using 6-0 silk sutures.
The second stage was originally done after about two months. Now it is done between 4-6 weeks.
Second Stage:
- A convex shaped new eyelid margin is marked on the flap between the two canthi.
- Incision is made through the flap, with the skin edge relatively shorter than the conjunctival edge, which can be everted upwards and utilized to form the new eyelid margin.
- The remainder of the flap is then retracted below the bridge and is sutured to the lower edge of the lower eyelid bridge in two layers.
Complications
Common complications of this procedure include:
- Cicatricial entropion of the reconstructed eyelid (2)(3)(4)
- Retraction or poor contour of the reconstructed eyelid (2)(3)(4)
- Lagophthalmos (3)
- Ectropion of the donor eyelid (2)(3)(4)
- Loss of bridge (4)(5)
- Lymphedema (3)
Modifications
Cutler and Beard found that that scarred upper lid flap was firm enough without tarsus. However, later reports linked missing tarsus to cicatricial entropion and recommended tarsal substitutes during the first stage of the procedure (2)(4). One technique involves suturing preserved sclera to the tarsal remnants between the conjunctival and the skin-muscle layers (4). This technique is complicated by the tendency for sclera to shrink in size. Other techniques include autologous transplants of ear cartilage, nasal septum, and free tarsus graft from the contralateral upper eyelid (3)(4).
Additional Resources
References
- Cutler NL, Beard C. A method for partial and total upper lid reconstruction. American Journal of Ophthalmology. 1955;39(1):1-7.
- Fischer T, Noever G, Langer M, Kammer E. Experience in upper eyelid reconstruction with the Cutler-Beard technique. Annals of Plastic Surgery. 2001;47(3):338-342.
- Pushker N, Agrawal S, Angku H, Thakur H, Raj R, Meel R, Bajaj MS. Double-bridge novel modification of Cutler-Beard flap for the reconstruction of full-thickness eyelid deformity. Indian Journal of Ophthalmology. 2026;74(9):1298-1301.
- Carroll RP. Entropion following the Cutler-Beard procedure. Ophthalmology. 1983;90(9):1052-1055.
- Putterman AM. The Cutler-Beard clamp for lid reconstruction. Ophthalmology. 2003;110(4):827-830.

